Wow, how time flies! It’s only just over two weeks away from the start of RTC Australasia.
If you haven’t registered yet, get in quick. If you register by 12pm on the 1st May you have the chance to take home a Dell M6700 17″ Mobile Workstation, as posted by Wesley earlier [...]
Just a quick post to remind you all that the Inaugural BrisBIM Gathering is tomorrow, Tuesday 23rd April.
There are some great presentations lined up:
Arrive from 5:00pm
5:30pm – Introduction & Announcements
5:40pm – My BIM’s bigger than your BIM!, Franz Hein (Woods Bagot)
6:00pm – Realising the advantages of [...]
Another quick tip, obvious but a bit too hidden for some;
Question: Why don’t my exported DWGs relate to the shared Revit coordinates?
Answer: If you want your exported DWGs to retain the shared co-ordinates you’ve set up in Revit, ensure that you have the correct settings enabled! The required setting is tucked away under [...]
This problem has not only been around for a long time but has also been fairly well documented, including workarounds. But I’m still surprised how often I hear about people battling with it! It can be triggered by all manner of miniaturised problems but one that seems to occur more frequently is moving an element by a [...]